Dell Latitude D630 Service Manual - Page 11

Back to Contents Page Display Assembly Dell™ Latitude™ D630 Service Manual Removing the Display Assembly Removing the Display Bezel Removing the Display Panel Removing the Display Panel Brackets Removing the Display Panel Cable Removing the Display Hinges Removing the Display Assembly CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer. 1. Follow the instructions in Before You Begin. 2. Remove the hinge cover (see Hinge Cover). 3. Remove the keyboard (see Removing the Keyboard). 4. Review the cable routing diagram: 1 WWAN/FCM card connector 4 WLAN card 7 WLAN antenna cables (white and gray) 2 WWAN antenna cables 5 pull-tab 8 WLAN antenna cable (gray; currently unused) 3 WLAN antenna cables (black and white) 6 display cable NOTICE: To avoid damage to your computer, use the illustration above when replacing the display assembly to carefully reroute the cables in the appropriate cable channels. Route the gray and black antenna cables beneath the white antenna cable, and the black display cable on top of the white antenna cable. 5. Pull straight up on the pull-tab that is attached to the display cable to disconnect the cable from the system board. 6. Disconnect the antenna cables from their card(s) (see Communications Cards). 7. Carefully remove the antenna cables and the display cable from their routing guides. 8. Close the display. 9. Turn the computer upside down with the back of the computer facing you.