Dell Latitude E5450 Dell LatitudeE5450 / 5450 Owners Manual - Page 17

Installing the Palmrest, Removing the SmartCard Reader Board, keyboard, keyboard trim, battery

Get Dell Latitude E5450 PDF manuals and user guides View all Dell Latitude E5450 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Installing the Palmrest 1. Place the palmrest on the computer. 2. Connect the following cables to their connectors on the system board: a. LED board b. USH board c. touchpad board 3. Tighten the screws to secure the palmrest to the computer. 4. Install the: a. keyboard b. keyboard trim c. battery d. base cover 5. Follow the procedures in After Working Inside Your Computer Removing the SmartCard Reader Board 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a. base cover b. battery c. memory d. keyboard trim e. keyboard f. palmrest 3. Perform the following steps: a. Disconnect the SmartCard reader board cable from the USH board [1] [2]. b. Peel the cable to release from the adhesive [3]. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Installing the Palmrest
1.
Place the palmrest on the computer.
2.
Connect the following cables to their connectors on the system board:
a.
LED board
b.
USH board
c.
touchpad board
3.
Tighten the screws to secure the palmrest to the computer.
4.
Install the:
a.
keyboard
b.
keyboard trim
c.
battery
d.
base cover
5.
Follow the procedures in
After Working Inside Your Computer
Removing the SmartCard Reader Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a.
base cover
b.
battery
c.
memory
d.
keyboard trim
e.
keyboard
f.
palmrest
3.
Perform the following steps:
a.
Disconnect the SmartCard reader board cable from the USH board [1] [2].
b.
Peel the cable to release from the adhesive [3].
17