Dell OptiPlex 3010 Owners Manual - Page 56
Write fault on selected drive
View all Dell OptiPlex 3010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Timer chip counter 2 failed Description A chip on the system board may be malfunctioning. Unexpected interrupt in protected mode Description The keyboard controller may be malfunctioning or a memory module may be loose. WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/ secondary] EIDE controller is operating outside of normal specifications. It is advisable to immediately back up your data and replace your hard drive by calling your support desk or Dell. Description During initial startup, the drive detected possible error conditions. When your computer finishes booting, immediately back up your data and replace your hard drive (for installation procedures, see "Adding and Removing Parts" for your computer type). If no replacement drive is immediately available and the drive is not the only bootable drive, enter System Setup and change the appropriate drive setting to None. Then remove the drive from the computer. Write fault Description The operating system cannot write to the floppy or hard drive. Write fault on selected drive Description The operating system cannot write to the floppy or hard drive. X:\ is not accessible. The device is not ready Description The floppy drive cannot read the disk. Insert a floppy disk into the drive and try again. 56