Dell OptiPlex 7010 Owner's Manual (Ultra Small Form Factor) - Page 27
Installing the Processor, Removing the System Board
View all Dell OptiPlex 7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installing the Processor 1. Insert the processor into the processor socket. Ensure the processor is properly seated. 2. Press the release lever down and then move it inward to secure it with the retention hook. 3. Install the heat sink. 4. Install the drive cage. 5. Install the front bezel. 6. Install the cover. 7. Follow the procedures in After Working Inside Your Computer. Removing the System Board 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a) cover b) front bezel c) drive cage d) system fan e) power supply f) heat sink g) processor h) memory i) input/output panel j) WLAN card k) speaker 3. Disconnect all the cables connected to the chassis. 4. Disconnect all the cables connected to the system board. 27
Installing the Processor
1.
Insert the processor into the processor socket. Ensure the processor is properly seated.
2.
Press the release lever down and then move it inward to secure it with the retention hook.
3.
Install the heat sink.
4.
Install the drive cage.
5.
Install the front bezel.
6.
Install the cover.
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a)
cover
b)
front bezel
c)
drive cage
d)
system fan
e)
power supply
f)
heat sink
g)
processor
h)
memory
i)
input/output panel
j)
WLAN card
k)
speaker
3.
Disconnect all the cables connected to the chassis.
4.
Disconnect all the cables connected to the system board.
27