Dell OptiPlex GXi Service Manual (.pdf) - Page 122
Inch Drive Removal
View all Dell OptiPlex GXi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
To remove a 5.25-inch drive assembly from the middle or lower drive bay, follow these steps: 1. Disconnect the DC power cable and the interface cable from the back of the drive. 2. Press in on the two retaining tabs (one on each side of the drive), and slide the drive assembly forward to remove it. 3. Remove the four screws attaching the 5.25-inch drive to the mounting plate, and lift the drive out of the mounting plate (see Figure 6-11). align the front of the drive flush with the tab at the front of 5.25-inch drivemounting plate screws (4) Figure 6-11. 5.25-Inch Drive Removal When you replace the 5.25-inch drive, align the front of the drive flush with the tab at the front of the mounting plate. Insert the four screws, and tighten them in the order stamped on the bottom of the 5.25-inch drive-mounting plate. 6-12 Dell OptiPlex GXi Systems Service Manual