Dell PowerConnect W-Airwave W-Airwave 7.3 User Guide - Page 94

Figure 56 illustrates these components and this navigation: Figure 56 Groups > Cisco WLC Config > Security Navigation Illustration Configuring Management Settings for Cisco WLC AMP allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. Users should be able to configure up to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global Groups. To define SNMP and server settings, go to the Groups > Cisco WLC Config > Management page, illustrated in Figure 57. Figure 57 Groups > Cisco WLC Config > Management Navigation Illustration Configuring Group PTMP Settings The Groups > PTMP configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base stations in the device group. Subscriber stations must be in the same group as all base stations with which they might connect. Perform the following steps to configure these functions. 1. Go to the Groups > List page and select the group for which to define PTMP settings by selecting the group name. Alternatively, select Add from the Groups > List page to create a new group, define a group name. In either case, the Monitor page appears. 2. Select the PTMP tab in the AMP navigation menu. Figure 58 illustrates this page. Figure 58 Groups > PTMP Page Illustration 94 | Configuring and Using Device Groups in AMP Dell PowerConnect W-AirWave | Version 7.3