Dell PowerEdge M520 Dell 10 Gb Ethernet Pass Through-k  for M1000e So - Page 13

3 Command Line Interface (CLI) Reference Rev 1.00 10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described in this section after successfully connecting to the 10GbE PTM CLI according to the procedure described in Section 2, "Connecting to the 10GbE PTM CLI," on page 9. 3.1 CLI Privilege Levels The 10GbE PTM supports the following user privilege levels: • USER - Common user level, indicated by the # prompt • ADMIN - Administrator level, indicated by the & prompt Different commands are available in different privilege levels. The command reference indicates the required privilege level for each command that requires a privilege level higher than USER. 3.2 Quick Reference Table 5 provides a quick reference to the CLI commands: Table 5 - List of Commands Command name Short Description Reference General Commands help Shows the list of available commands login Change privilege level exit Exit current privilege level reload Restart the module: Hardware reset and software reload Software Image Commands show image ver Shows the software image version copy image from- Upload new software image to the PTM file Section 3.4.1, "help," on page 14 Section 3.4.2, "login (ADMIN)," on page 15 Section 3.4.3, "exit," on page 15 Section 3.4.4, "reload," on page 15 Section 3.5.1, "show image ver," on page 16 Section 3.5.2, "copy image from-file," on page 16 Device Commands show device temp Shows the temperature of a specified device Section 3.6.1, "show device temp (ADMIN)," on page 17 Port Commands 13