Dell PowerEdge M520 Dell 10 Gb Ethernet Pass Through-k for M1000e So - Page 16
Software Update Commands - firmware update
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Rev 1.00 Software User's Manual Description: Use this command to restart the module components. When this command is issued, PTM components go through a full hardware reset, followed by software reload. Options: • device_number: specify a single device to reset Example: $ reload 3.5 Software Update Commands 3.5.1 show image ver Synopsys: show image ver Description: Display the current software image version. ADMIN: This command also displays the firmware version of each component. Example: # login admin & show image ver Software image short version: V Z.ZZ Software image version: X.X.XXX- Component #1 firmware version: Y.Y.YYY Component #2 firmware version: Y.Y.YYY Component #3 firmware version: Y.Y.YYY & login user 3.5.2 copy image from-file Synopsys: copy image from-file [device_number] Description: Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a single device in the PTM. Immediately after running this command, the CLI waits for the user to send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For additional details on the firmware update procedure refer to Section 4, "Operating Procedures," on page 22. ADMIN: 16