Dell PowerEdge M520 Dell 10 Gb Ethernet Pass Through-k  for M1000e So - Page 9

Connecting to the 10GbE PTM CLI

Get Dell PowerEdge M520 PDF manuals and user guides View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

2 Connecting to the 10GbE PTM CLI Rev 1.00 If you are connecting to the system over a network, you will need an SSH client that supports ZModem file transfer. The examples in this document use Secure CommNet v2.35 (download from www.radient.com). After you download the software, some initial configuration is necessary. Please follow the next configuration steps; when using a different client software, similar settings should be available. If you are connecting directly to the serial port of the Chassis Management Console (CMC), skip to step (9). 1. Go to Setup => SSH2 settings, and set the compression to none. Figure 4: Setup > SSH2 Settings Figure 5: Set Compression to "none" 2. Go to Setup => Terminal Settings 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Rev 1.00
9
2
Connecting to the 10GbE PTM CLI
If you are connecting to the system over a network, you will need an SSH client that supports
ZModem file transfer. The examples in this document use Secure CommNet v2.35 (download
from
www.radient.com
). After you download the software, some initial configuration is necessary.
Please follow the next configuration steps; when using a different client software, similar settings
should be available.
If you are connecting directly to the serial port of the Chassis Management Console (CMC), skip
to step (9).
1.
Go to Setup => SSH2 settings, and set the compression to
none
.
Figure 4: Setup > SSH2 Settings
Figure 5: Set Compression to “none”
2.
Go to Setup => Terminal Settings