Dell PowerEdge MX7000 EMC OpenManage Enterprise Modular Edition Version 1.10.0 - Page 13

Input Example racadm cmcchangeover NA NOTE: During a failover, the chassis power state on the OME - Modular GUI is displayed as "off". The original power state is displayed after the inventory is refreshed. config Description Synopsis Modifies the configuration properties of the management module. racadm config -g -o [-m ] Input Example racadm config -g -i -o • -g-Configuration group to which the object belongs • -o-Configuration object to configure • -i-Index of indexed group, which is used with -g and -o • -m-The module must have one of the following values: - storage-- where n=1 to 8 NOTE: The storage - option is available only for cfgStorageModule • -Value of the configuration object • Configure a single property of a group: racadm config -g cfgLanNetworking -o cfgDNSRacName NAME • Configure a single property of a group for a particular user: racadm config -g cfgUserAdmin -i 2 -o cfgUserAdminPassword PASSWORD connect Description Synopsis Connects to switch or blade serial console. The connect command is supported only on firmware interfaces. racadm connect [-b] -m Input Example • -b-Binary mode If -b is used, reset OME-Modular to terminate the connect. • -m-The option must be one of the following values: • server--where n = 1-8 • switch--where n = 1-6 CAUTION: When run from the OME-Modular serial console, the connect -b option stays connected until the management module resets or the serial console is terminated. This connection is a potential security risk. NOTE: The racadm connect to server prompts you to enter the iDRAC credentials for connecting to the server. • Connect to server 1 serial console: racadm connect -m server-1 RACADM sub command details 13