Dell PowerEdge MX7000 EMC OpenManage Enterprise Modular Edition Version 1.00.1 - Page 16

getpbinfo Description Synopsis Input Example Gets power budget status information. If there is no power supply to the PSU, the output of the command is displayed as "failed". If there is a mismatch in the power source, for example, a PSU of 220 volts and PSU of 110 volts are combined, then the output of the command is displayed as "Configuration Error". racadm getpbinfo racadm getpbinfo racadm getpbinfo [Power Budget Status] System Input Power = 615 W (2098 BTU/h) Peak System Power = 628 W (2142 BTU/h) Peak System Power Timestamp = 11:37:36 08/08/2018 Minimum System Power = 606 W (2067 BTU/h) Minimum System Power Timestamp = 10:16:08 08/06/2018 Overall Power Health = Not OK Redundancy = No System Input Power Cap = Disabled Redundancy Policy = None Dynamic PSU Engagement Enabled = Not Applicable System Input Max Power Capacity = 11571 W Input Redundancy Reserve = Not Applicable Input Power Allocated to Servers = Not Applicable Input Power Allocated to Chassis Infrastructure = Not Applicable Total Input Power Available for Allocation = 2385 W (8137 BTU/h) Standby Input Power Capacity = Not Applicable Server Based Power Management Mode = Not Applicable Max Power Conservation Mode = Not Applicable Server Performance Over Power Redundancy = Not Applicable Power Available for Server Power-on = Not Applicable Extended Power Performance(EPP) Status = Not Applicable Available Power in EPP Pool = Not Applicable Used Power in EPP Pool = Not Applicable EPP Percent - Available = Not Applicable [Chassis Power Supply Status Table] State>