Dell PowerEdge R415 Hardware Owner's Manual - Page 50

Table 1-3. System Messages (continued) Message Causes Corrective Actions Unable to launch System Services image. System halted! System halted after Restart the system and keystroke because System update Lifecycle Controller Services image is either by running the Lifecycle corrupted in the system Controller Dell Update firmware or has been lost due Package (DUP). For more to system board replacement. information, see the Dell The iDRAC6 Enterprise card flash memory may be corrupted. Update Packages User's Guide at support.dell.com/manuals. If the system still reports the same error, run the Lifecycle Controller Repair Package. Follow the instructions provided with the package to complete the installation. Unexpected interrupt in protected mode. Improperly seated memory modules or faulty keyboard/mouse controller chip. Reseat the memory modules. See "Troubleshooting System Memory" on page 157. If the problem persists, see "Getting Help" on page 181. Unsupported CPU combination. Unsupported CPU stepping detected. Processor(s) not supported by the system. Install a supported processor or processor combination. See "Processors" on page 127. Unsupported DIMM detected. The following DIMM has been disabled: x Invalid memory configuration. The system will run but with the specified memory module disabled. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 122. 50 About Your System