Dell PowerStore 9000T EMC PowerStore Installation and Service Guide - Page 102
Unplugging the power cord from an AC power supply/cooling module
View all Dell PowerStore 9000T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Figure 131. Unplugging the power cord from an AC power supply/cooling module 3. On a DC power/cooling module, pinch the spring releases on each side of the power cord plug and pull the plug out of the connector. Spring Release CL5060 Figure 132. Unplugging the power cord from a DC power supply/cooling module 4. Remove the power/cooling module as follows: a. Press the orange handle button to release the module. b. Pull the latch outward, and remove the power/cooling module from its slot. CAUTION: To protect a running system from overheating, the enclosure powers down unless you replace the power cooling module within two minutes. 102 Expansion enclosure service procedures
Figure 131. Unplugging the power cord from an AC power supply/cooling module
3.
On a DC power/cooling module, pinch the spring releases on each side of the power cord plug and pull the plug out of the connector.
Spring
Release
CL5060
Figure 132. Unplugging the power cord from a DC power supply/cooling module
4.
Remove the power/cooling module as follows:
a.
Press the orange handle button to release the module.
b.
Pull the latch outward, and remove the power/cooling module from its slot.
CAUTION:
To protect a running system from overheating, the enclosure powers down unless you replace the
power cooling module within two minutes.
102
Expansion enclosure service procedures