Dell PowerStore 9000T EMC PowerStore Installation and Service Guide - Page 36
Replace an embedded module, Identify a faulted part from PowerStore Manager, Embedded module LEDs
View all Dell PowerStore 9000T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
a. Open PowerStore Manager. b. Click Settings on the upper right of the screen. c. Click General Support. d. Under Drives, Power Supplies, and Other Parts, click Return Part. e. If your screen does not show the Return Part link, contact your service provider for instructions. Replace an embedded module Take the following actions to remove the faulted embedded module and install the replacement embedded module into the system. Identify a faulted part from PowerStore Manager Before you replace a part, ensure that you have identified its location within the system. Using PowerStore Manager, you can identify and locate a faulted part. Steps 1. From PowerStore Manager, select Hardware. 2. Select the appliance that contains the faulted part. 3. From the Hardware card, select the view of the system where the faulted part is located. Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field. Embedded module LEDs Use the fault LEDs to identify the faulted part. Figure 30. Embedded module LEDs Table 2. Embedded module LEDs LED Embedded module fault Location Ethernet port link Ethernet port activity SAS port and activity link Port link 36 Base enclosure service procedures State Amber Off Green Off Amber blinking Off Blue Off Green Amber Off Description Embedded module has faulted. No fault has occurred, normal operation. Link established. No link established. Port activity. No port activity. SAS port link is up. No link established. Link up with high speed. Link up with degraded speed. Link down.