Dell PowerVault 50F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 43

To enter an IP address, perform the following steps: 1. Use and to increase or decrease the displayed value. The under- lined cursor indicates the numbers to modify. 2. After entering a number, press to move the cursor to modify the next field. 3. After setting the Fibre Channel's IP address, press to store the value. Pressing while Fibre Channel Subnetmask is selected displays the Fibre Channel's subnet mask address. The default subnet mask value is none. Consult your network administrator for the appropriate subnet mask Enter the switch's Fibre Channel Subnetmask by using and to increase or decrease the displayed value. Pressing while Gateway address is selected displays the fibre channel's gateway address. The default gateway address is required. . You must enter a valid gateway address, if To enter a gateway address, perform the following steps: 1. Use and to increase or decrease the displayed value. The under- lined cursor indicates the numbers to modify. 2. After entering a number, press to move the cursor to modify the next field. 3. After setting the Fibre Channel's IP address, press to store the value. The domain number uniquely identifies the switch in a fabric. This switch ID is normally automatically assigned by the switch and may be any value between 1 and 239. If VC-Encoded Address Mode is in effect, then the values are between 0 and 31. You may also assign this number manually. Pressing while BB_credit is selected displays the number of buffers available to the host. support.dell.com Managing the PowerVault 56F 16-Port Fibre Channel Switch 3-9