Dell PowerVault 50F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 77
ifShow, ipAddrSet, Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, Fibre Channel
View all Dell PowerVault 50F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
The ifShow command displays a summary of currently running tasks. The display includes three sections organized by interface: - Ethernet 10/100BASE-T port - Loopback interface - Fibre Channel; this section is omitted if IP over Fibre Channel is not configured The following example shows the ipAddrSet command, which sets the switch's Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, Fibre Channel subnetmask, and gateway address. The fields are described in Table 4-11. switch:admin> ipAddrSet Ethernet IP Address [192.168.90.241]: Ethernet Subnetmask [none]: Fibre Channel IP Address [192.168.65.241]: Fibre Channel Subnetmask [none]: Gateway Address [192.168.90.1]: NOTE: Consult your network administrator for the appropriate IP address(es), subnetmask(s), and gateway address. Ethernet IP address The default IP address on a new switch is a temporary number derived from the switch's World Wide Names (WWN); enter a valid IP address Ethernet subnetmask The Ethernet subnetmask value; the default subnetmask value is none; see your network administrator for the appropriate subnetmask value to enter here Fibre Channel IP address The Fibre Channel IP address for the switch; enter a valid IP address (not currently supported) Fibre Channel subnetmask The Fibre Channel subnetmask for the switch; the default is none Gateway IP address The gateway IP address; the default gateway address on a new switch is none; you must enter a valid gateway address, if required support.dell.com PowerVault 56F 16-Port Fibre Channel Switch Commands 4-21