Dell PowerVault MD3220i Owner's Manual - Page 26
Indicator, Button, or, Connector, Description, Split mode LED
View all Dell PowerVault MD3220i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Item Indicator, Button, or Icon Connector 3 Split mode LED 4 System identification button 5 Hard drives 6 Enclosure mode switch Description This LED should be unlit as the split mode function is not supported by the MD3200i Series Storage Arrays. The system identification button on the front control panel can be used to locate a particular enclosure within a rack. When the button is pushed, the system status indicators on the control panel and the RAID controller module(s) blink blue until the button is pushed again. PowerVault MD3200i-Up to 12 3.5-inch SAS hot-swappable hard drives. PowerVault MD3220i-Up to 24 2.5-inch SAS hot-swappable hard drives. The function of this switch is not applicable to your storage array. However, if MD1200 Series expansion enclosures are daisy chained to the storage array, the enclosure mode switches of the MD1200 Series expansion enclosures must be set to the Unified-Mode position. NOTE: This switch must be set prior to turning on the MD1200 series expansion enclosure. Changing the switch setting after the expansion enclosure is turned on has no effect on enclosure configuration until the expansion enclosure goes through a complete power cycle. 26 Planning: About Your Storage Array