Dell UP3218K Users Guide - Page 42
Power Save, If either DP 1, DP 2 input is selected and the corresponding cable is not connected
![]() |
View all Dell UP3218K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
When the monitor enters the Power Save mode, the following message appears: Dell UltraSharp 32 Monitor Entering Power Save Mode. UP3218K Activate the computer and wake up the monitor to gain access to the OSD. If you press any button other than the power button, the following messages will appear depending on the selected input: Dell UltraSharp 32 Monitor No DP 1 signal from your device. Press any key on the keyboard or move the mouse or wake it up. If there is no display, press the monitor button again to select the correct input source. UP3218K If either DP 1, DP 2 input is selected and the corresponding cable is not connected, a floating dialog box as shown below appears. Dell UltraSharp 32 Monitor No DP 1 Cable The display will go into Power Save Mode in 4 minutes. www.dell.com/support/monitors or Dell UltraSharp 32 Monitor UP3218K No DP 2 Cable The display will go into Power Save Mode in 4 minutes. www.dell.com/support/monitors See Troubleshooting for more information. UP3218K 42 | Operating the Monitor
![](/manual_guide/products/dell-up3218k-users-guide-4e7e46c/42.png)