Dell Vostro 1710 Service Manual - Page 6

Internal Card With Bluetooth, Wireless Technology

Page 6 highlights

Back to Contents Page Internal Card With Bluetooth® Wireless Technology Dell™ Vostro™ 1710 Service Manual Removing the Card Replacing the Card CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. If you ordered a card with Bluetooth wireless technology with your computer, the card is already installed. Removing the Card 1. Follow the procedures in Before Working on Your Computer. 2. Remove the hard drive cover. See Removing the Hard Drive for an illustration of the hard drive cover. 3. Remove the M2 x 3-mm screw that connects the card to the base of the computer. 4. Lift the card and cable and disconnect the card connector from the card. 5. Remove the card from the card compartment. 1 card cable connector 2 card Replacing the Card CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. This procedure assumes that you have completed the removal procedure Removing the Card. 1. Connect the cable to the card. 2. Replace the card in the card compartment. 3. Replace the M2 x 3-mm screw that connects the card to the base of the computer. 4. Replace the hard drive cover. See Removing the Hard Drive for an illustration of the hard drive cover. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58

Back to Contents Page
Internal Card With Bluetooth
®
Wireless Technology
Dell™ Vostro™ 1710
Service Manual
Removing the Card
Replacing the Card
If you ordered a card with Bluetooth wireless technology with your computer, the card is already installed.
Removing the Card
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the hard drive cover. See
Removing the Hard Drive
for an illustration of the hard drive cover.
3.
Remove the M2 x 3-mm screw that connects the card to the base of the computer.
4.
Lift the card and cable and disconnect the card connector from the card.
5.
Remove the card from the card compartment.
Replacing the Card
This procedure assumes that you have completed the removal procedure
Removing the Card
.
1.
Connect the cable to the card.
2.
Replace the card in the card compartment.
3.
Replace the M2 x 3-mm screw that connects the card to the base of the computer.
4.
Replace the hard drive cover. See
Removing the Hard Drive
for an illustration of the hard drive cover.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
1
card cable connector
2
card
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.