Dell Vostro 5401 Service Manual - Page 59
Installing the I/O board - discrete
View all Dell Vostro 5401 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
8. Remove the three screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly. 9. Lift the I/O board off the palm-rest and keyboard assembly. Installing the I/O board - discrete Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the I/O board and provides a visual representation of the installation procedure. Steps 1. Place the I/O board on the palm-rest and keyboard assembly. 2. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly. 3. Replace the three screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly. 4. Connect the fingerprint reader cable to the I/O board and close the latch to secure the cable. 5. Lower the left hinge, and replace the two screws (M2.5x4) and (M2x3). 6. Route the I/O cable underneath the system fan using adhesive tape. 7. Connect the I/O-board cable to the I/O board and close the latch to secure the cable. Disassembly and reassembly 59