Dell W-7200 PowerConnect Series Controller Installation Guide - Page 9

Figure 2 10/100/1000Base-T Management Port Pin Out 1000Base-T Gigabit Ethernet Port RJ-45 Female Pin-Out 1 2 3 4 5 6 7 8 Signal Name BI_DA+ BI_DABI_DB+ BI_DC+ BI_DCBI_DBBI_DD+ BI_DD- Function Bi-directional pair +A Bi-directional pair -A Bi-directional pair +B Bi-directional pair +C Bi-directional pair -C Bi-directional pair -B Bi-directional pair +D Bi-directional pair -D 1000Base-X (SFP) Ports The W-7200 controller is equipped with two 1000Base-X combination ports for fiber connectivity only and are intended for use with Dell SFPs (mini-GBICs). NOTE: Dell tests and supports optics offered through Dell W-Series products within Dell controller systems. Third party optics are not tested or supported; therefore, Dell does not guarantee proper functionality of third party optics when used in a Dell controller. Dual-Media Port LEDs Each pair of Dual-Media ports is equipped two LEDs that allow you to monitor the status of and activity on the port. These LEDs provide basic monitoring of the status, activity, and basic configuration of each port. The information displayed by these LEDs can be changed via the LCD.  LINK/ACT: on the left side of the port, displays the link status of the port.  Status: on the right side of the port, displays the status of the port. The information displayed by this LED changes based on LCD's mode. The LED behavior for each mode is described in Table 4 and Table 5. Table 4 10/100/1000Base-T Port LEDs LED Function LCD Mode Indicator Status LINK/ACT Status Link status N/A Port status Administrative Duplex Speed Green (Solid) Green (Blinking) Off Green (Solid) Off Green (Solid) Off Green (Solid) Off Link has been established Port is transmitting or receiving data No link Port Enabled Port Administratively Disabled Full-duplex Half-duplex 1000 Mbps 10/100 Mbps Dell PowerConnect W-7200 Series Controller | Installation Guide Dell PowerConnect W-7200 Controller | 9