Dell W-Series 314 Instant 6.4.3.1-4.2 User Guide - Page 119
Wired Profiles, Configuring a Wired Profile, Configuring Wired Settings, In the Instant UI
View all Dell W-Series 314 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Chapter 10 Wired Profiles This chapter describes the following procedures: l Configuring a Wired Profile on page 119 l Assigning a Profile to Ethernet Ports on page 124 l Editing a Wired Profile on page 124 l Deleting a Wired Profile on page 124 l Link Aggregation Control Protocol on page 125 l Understanding Hierarchical Deployment on page 126 Configuring a Wired Profile The Ethernet ports allow third-party devices such as VoIP phones or printers (which support only wired connections) to connect to the wireless network. You can also configure an Access Control List (ACL) for additional security on the Ethernet downlink. The wired profile configuration for employee network involves the following procedures: 1. Configuring Wired Settings on page 119 2. Configuring VLAN for a Wired Profile on page 120 3. Configuring Security Settings for a Wired Profile on page 121 4. Configuring Access Rules for a Wired Profile on page 122 For information on creating a wired profile for guest network, see Captive Portal for Guest Access Configuring Wired Settings You can configure wired settings for a wired profile by using the Instant UI or CLI. In the Instant UI 1. Click the Wired link under More at the top right corner of the Instant main window. The Wired window is displayed. 2. Click New under Wired Networks. The New Wired Network window is displayed. 3. Click the Wired Settings tab and configure the following parameters: a. Name- Specify a name for the profile. b. Primary Usage-Select Employee or Guest. c. Speed/Duplex-Ensure that appropriate values are selected for Speed/Duplex. Contact your network administrator if you need to assign speed and duplex parameters. d. POE-Set POE to Enabled to enable Power over Ethernet. e. Admin Status-Ensure that an appropriate value is selected. The Admin Status indicates if the port is up or down. 4. Click Show advanced options and configure the following parameters as required. a. Content Filtering- To ensure that all DNS requests to non-corporate domains on this wired network are sent to OpenDNS, select Enabled for Content Filtering. b. Uplink-Select Enabled to configure uplink on this wired profile. If Uplink is set to Enabled and this network profile is assigned to a specific port, the port will be enabled as Uplink port. For more Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide Wired Profiles | 119