Dell W-Series 314 Instant 6.4.3.1-4.2 User Guide - Page 120
In the CLI, Configuring VLAN for a Wired Profile, In the Instant UI
![]() |
View all Dell W-Series 314 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
information on assigning a wired network profile to a port, see Assigning a Profile to Ethernet Ports on page 124. c. Spanning Tree-Select the Spanning Tree checkbox to enable Spanning Tree Protocol (STP) on the wired profile. STP ensures that there are no loops in any bridged Ethernet network and operates on all downlink ports, regardless of forwarding mode. STP will not operate on the uplink port and is supported only on W-IAPs with three or more ports. By default Spanning Tree is disabled on wired profiles. d. Inactivity Timeout-Specify the time out interval within the range of 60-86400 seconds for inactive wired clients. The default interval is 1000 seconds. 5. Click Next. The VLAN tab details are displayed. 6. Configure VLAN for the wired profile. For more information, see Configuring VLAN for a Wired Profile on page 120. In the CLI To configure wired settings for: (Instant AP)(config)# wired-port-profile (Instant AP)(wired ap profile )# type { |} (Instant AP)(wired ap profile )# speed {10 |100 |1000 |auto} (Instant AP)(wired ap profile )# duplex {half|full|auto} (Instant AP)(wired ap profile )# no shutdown (Instant AP)(wired ap profile )# poe (Instant AP)(wired ap profile )# uplink-enable (Instant AP)(wired ap profile )# content-filtering (Instant AP)(wired ap profile )# spanning-tree (Instant AP)(wired ap profile )# end (Instant AP)# commit apply Configuring VLAN for a Wired Profile If you are creating a new wired profile, complete the Wired Settings procedure before configuring VLAN. For more information, see Configuring Wired Settings on page 119. You can configure VLAN using the Instant UI or CLI. In the Instant UI To configure VLAN: 1. In the VLAN tab, enter the following information. a. Mode-You can specify any of the following modes: l Access-Select this mode to allow the port to carry a single VLAN specified as the native VLAN. l Trunk-Select this mode to allow the port to carry packets for multiple VLANs specified as allowed VLANs. b. Specify any of the following values for Client IP Assignment: l Virtual Controller Assigned: Select this option to allow the Virtual Controller to assign IP addresses to the wired clients. When the Virtual Controller assignment is used, the source IP address is translated for all client traffic that goes through this interface. The Virtual Controller can also assign a guest VLAN to a wired client. l Network Assigned: Select this option to allow the clients to receive an IP address from the network to which the Virtual Controller is connected. On selecting this option, the New button to create a VLAN is displayed. Create a new VLAN if required. c. If the Trunk mode is selected: 120 | Wired Profiles Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide
![](/manual_guide/products/dell-wseries-314-instant-643142-user-guide-1c4a56b/120.png)