Dell W-Series 314 Instant 6.4.3.1-4.2 User Guide - Page 216
Local, L2, L3, Excluded address, Domain Name, Lease Time, Option, Table 40
View all Dell W-Series 314 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 216 highlights
3. Based on type of DHCP scope selected, configure the following parameters: Table 40: Local DHCP Mode Configuration Parameters Name Description Name Enter a name for the DHCP scope. Type Select any of the following options: l Local-On selecting Local, the DHCP server for local branch network is used for keeping the scope of the subnet local to the W-IAP. In the NAT mode, the traffic is forwarded through the IPSec tunnel or the uplink. l Local, L2-On selecting Local, L2, the Virtual Controller acts as a DHCP server and a default gateway in the local network is used. l Local, L3-On selecting Local, L3, the Virtual Controller acts as a DHCP server and gateway. In this mode, the network address for traffic destined to the corporate network is translated at the source with the inner IP of the IPSec tunnel and is forwarded through the IPsec tunnel. The traffic destined to the noncorporate network is routed. VLAN Specify a VLAN ID. To use this subnet, ensure that the VLAN ID specified here is assigned to an SSID profile. For more information on SSID profile configuration, see Configuring VLAN Settings for a WLAN SSID Profile on page 102 and Configuring VLAN for a Wired Profile on page 120. Network Specify the network to use. Netmask If Local, Local, L2 or Local, L3 is selected, specify the subnet mask. The subnet mask and the network determine the size of subnet. Excluded address Specify a range of IP addresses to exclude. You can add up to two exclusion ranges. Based on the size of the subnet and the value configured for Excluded address, the IP addresses either before or after the defined range are excluded. Default Router If Local, L2 is selected for type of DHCP scope, specify the IP address of the default router. DNS Server If required, specify the IP address of a DNS server for the Local, Local, L2 and Local, L3 scopes. Domain Name If required, specify the domain name for the Local, Local, L2, and Local, L3 scopes. Lease Time Specify a lease time for the client in minutes within a range of 2-1440 minutes. The default value is 720 minutes. Option Specify the type and a value for the DHCP option. You can configure the organization-specific DHCP options supported by the DHCP server. For example, 176, 242, and 161. To add multiple DHCP options, click the + icon. 4. Click OK. In the CLI To configure Local DHCP scope: (Instant AP)(config)# ip dhcp 216 | DHCP Configuration Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide