Dell Z9264F-ON EMC PowerSwitch Installation Guide March 2022 - Page 19

Ground lug assembly, Z9264F-ON switch installation

Get Dell Z9264F-ON PDF manuals and user guides View all Dell Z9264F-ON manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Figure 9. Ground lug assembly 3. Measure and cut a length of ground wire sufficient to reach between the system-installed ground lug assembly and your rack ground point. 4. Crimp the ground cable to the ground lug assembly. a. Coat the bare end of the wire with an antioxidant compound. b. Insert the end of the wire into the ground lug. c. Crimp the ground lug end. 5. Clean the bracket and lug surfaces thoroughly, and apply an antioxidant solution to the mating surfaces. 6. Attach the switch ground lug assembly to the switch. Figure 10. Ground lug assembly attached 7. Attach the GND lug bracket assembly to your switch using the two removed screws, as shown. Torque the M4 screws to ±8-10 in-lbs. Z9264F-ON switch installation 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Figure 9. Ground lug assembly
3.
Measure and cut a length of ground wire sufficient to reach between the system-installed ground lug assembly and your rack
ground point.
4.
Crimp the ground cable to the ground lug assembly.
a.
Coat the bare end of the wire with an antioxidant compound.
b.
Insert the end of the wire into the ground lug.
c.
Crimp the ground lug end.
5.
Clean the bracket and lug surfaces thoroughly, and apply an antioxidant solution to the mating surfaces.
6.
Attach the switch ground lug assembly to the switch.
Figure 10. Ground lug assembly attached
7.
Attach the GND lug bracket assembly to your switch using the two removed screws, as shown.
Torque the M4 screws to ±8–10 in-lbs.
Z9264F-ON switch installation
19