Denon AVR-2311 Owners Manual - English - Page 39

ENGLISH Set up speakers around items indicate the settings. Here we describe how to set up speakers other than 5.1-channel speakers. For the method of setting up 5.1-channel speakers, see "Simple version", "Set up speakers (Audyssey® Auto Setup)" (vpage 6). First install and connect the speakers to this unit. Before Auto Setup measurement, the settings shown below can be made. • Changing the amplifier assignment (Amp Assign) The signal output from the SURR.BACK / AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage 36 "Set up "Amp Assign""). • Setting the channels to be used (Channel Select) If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced (vpage 37 "Set up "Channel Select""). 1 Set up the remote control unit nn Set up the zone mode Press ZONE SELECT to switch the zone mode to "MAIN". The "MAIN" indicator lights. 2 Connect the setup microphone. When the setup microphone is connected, the following screen is displayed. Press ZONE SELECT nn Set up the operation mode Press AMP to set the remote control unit to amplifier operation mode. AUTO SETUP AUDYSSEY AUTO SETUP MultEQ STEP1 Preparation Connect the speakers and place them according to the recommendations in the manual. Set the following items if necessary. Amp Assign Channel Select Auto Setup Start [1/6] Start Auto Setup ENTER Enter RETURN Cancel 3 Set up "Amp Assign" Use ui to select "Amp Assign", and then press ENTER. AUTO SETUP AUDYSSEY AUTO SETUP MultEQ STEP1 Preparation Connect the speakers and place them according to the recommendations in the manual. Set the following items if necessary. Amp Assign Channel Select Auto Setup Start [1/6] ENTER Enter RETURN Cancel Set use of surround back ch. for your system 4 Use o p to select the configuration of the connected speakers, and then press RETURN. Normal ZONE2 Front Height Bi-Amp Front B 2CH Set when using 7.1-channel (Front/Center/Surround/Surround Back/Subwoofer) speakers. Set for connecting the speakers for ZONE2 to the SURR. BACK/ AMP ASSIGN terminals. Set for connecting the front height speakers to the SURR. BACK/AMP ASSIGN terminals. Set for connecting a tweeter of a front speaker to the SURR. BACK/AMP ASSIGN terminals and a woofer of the front speaker to the FRONT terminals. Set for connecting the second set of front speakers to the SURR. BACK/AMP ASSIGN terminals. Set for 2-channel direct/stereo playback. When "2CH" is set, connect the second set of front speakers to the SURR.BACK/ AMP ASSIGN terminals. Press AMP 36 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu