Denon CDR W1500 Owners Manual - Page 9

r Input source display • Each press of the input switching button (INPUT) causes the indicators to light as described below. ª CD : This lights when the input source is set to the internal CD. ª OPT : This lights when the DIGITAL IN OPTICAL input jacks are selected. ª COAX : This lights when the DIGITAL IN COAXIAL input jacks are selected. ª ANALOG : This lights when the ANALOG CD-R IN input jacks are selected. t Music calendar display • Tracks on a disc or in a program. • Track in play/recording. ✽ Off when both the CD and CD-R times are displayed. y Multiple display • This display indicates the number of tracks, track number, play time, recording time, various operational information, text messages, etc. • When both the CD and CD-R times are displayed, the CD-R time is displayed. u Level meter • Record level bar, indicates the audio signal level. • When the CD-R unit is set to the recording mode, the input level is displayed. i Track No. display • When there is text information, the track number is displayed. • When both the CD and CD-R times are displayed, the CD track number is displayed. o Time display • When there is text information, the time is displayed. • When both the CD and CD-R times are displayed, the CD time is displayed. ENGLISH 8 REMOTE CONTROL UNIT 2 The included remote control unit (RC-278) can be used to operate the CDR-W1500 from a distance. Inserting the batteries q Remove the remote control unit's back lid. w Insert the two R6P (AA) batteries in the battery compartment, in the direction indicated by the marks inside the compartment. e Put the back lid back on. Cautions on batteries • Use R6P (AA) batteries in the remote control unit. • The batteries should be replaced with new ones after approximately one year, though this depends on the frequency with which the remote control unit is used. • Even if the batteries are less than a year old, replace them with new ones if the remote control unit no longer operates even from a short distance from the main unit. • The included battery is only for verifying operation. Replace it with a new battery as soon as possible. • When inserting new batteries, wait about two minutes after removing the old batteries before inserting the new ones. • Be sure to set the batteries in the proper "" directions, as indicated by the marks in the remote control unit's battery compartment. • Remove the batteries when not using the remote control unit for long periods of time. • To avoid explosions and fluid leakage: • Do not use one new battery with one old one. • Do not use two different types of batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, wipe all the fluid off the battery compartment, then insert new batteries. Using the remote control unit PHONES LEVEL - 9 8 4 REC PAUSE FINALIZE STOP INPUT PLAY CLEAR TIME MENU OPEN /CLOSE • When operating the remote control unit, point it at the main unit as shown in the diagram. • The remote control unit can be operated from a direct distance of approximately 8 meters from the main unit. This distance will be shortened, however, if there are obstacles or when operated from an angle. (The remote control unit will operate from a horizontal angle of up to about 30°.) Approx. 8 meters 30° 30° CD-R CD REMLAOYDE 2 3 6 _NODRUMBABLING_HIGH ! " # % D 9 A 1 5 J ʢ



ʣ & ' G M ˎʴ 4 8 . ʗ 7 10 S , ʵ P Y ʻ

ʼ : ; V } { ? + CLEAR ] [ = 10 REC MENU 6 8 STOP 7 9 PAUSE B 2EPNROTEGR/DPIRLEACYTRACNADLOLMDISPL1ATYI/MSAELEL.LFA3DETRAIT-LINEBRPEUCMTHOARTAECCTOEFRNITNRALOIZLEUNIT RC-278 NOTES: • The remote control unit may not operate if the remote sensor is exposed to direct sunlight or strong artificial light, or if there is an obstacle between it and the remote sensor. • Do not press buttons on the main unit and on the remote control unit at the same time. Doing so will result in malfunction. 9