Dewalt DXGNR7000 Instruction Manual - Page 19
Battery Replacement/Connection, Valve Clearance, Inspect Spark Arrester Screen (CARB models), NOTICE - air filter
View all Dewalt DXGNR7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Maintenance 7. Slowly pour oil into oil fill opening until oil level is between L and H marks on dipstick. DO NOT overfill. 8. Install oil fill cap, and finger tighten. 9. Wipe up any spilled oil. 10. Properly dispose of oil in accordance with all applicable reg- ulations. Air Filter Engine will not run properly and may be damaged if run with a dirty air filter. Service air filter more frequently in dirty or dusty conditions. To service air filter: 1. Turn knob (A) and remove air filter cover. 2. Wash in soapy water. Squeeze filter dry in clean cloth (DO NOT TWIST). 3. Clean air filter cover before re-installing it. NOTICE: 431-6871. To order a new air filter, contact the nearest authorized service center at 1-888- 4. Install spark plug finger tight, and tighten an additional 3/8 to 1/2 turn using spark plug wrench. Battery Replacement/Connection The battery shipped with the generator has been fully charged. A battery may lose some charge when not in use for prolonged periods of time. If battery is unable to crank engine, plug in the 12V charger included in the accessory box (see the Charging a Battery section). IMPORTANT: RUNNING THE GENERATOR DOES NOT CHARGE BATTERY. WARNING Accidental Start-up. Disconnect the negative battery cable, then the posi- tive battery cable when working on unit. Failure to do so could result in death or serious injury. 1. Disconnect negative (-) battery terminal FIRST (A). 2. Disconnect positive (+) battery terminal SECOND (B). B 000809 A Service Spark Plug To service spark plug: 1. Clean area around spark plug. 2. Remove and inspect spark plug. 3. Inspect electrode gap with wire feeler gauge and reset spark plug gap to 0.028 - 0.031 in (0.70 - 0.80 mm). 000211 NOTICE: Replace spark plug if electrodes are pitted, burned or porcelain is cracked. Use ONLY recommended replacement plug. See Specifica- tions. 000224 A 3. Install new battery. Install hold down bracket and tighten. 4. Connect positive (+) battery terminal (B) FIRST (B). Slide rubber boot over connection hardware. 5. Connect negative (-) battery terminal (A) SECOND. 6. Slide rubber boot over connection hardware. Valve Clearance IMPORTANT: If uncomfortable about doing this procedure, or the proper tools are not available, take generator to the nearest service center to have valve clearance adjusted. Check valve clearance after the first fifty-hours of operation. Adjust as necessary. • Intake - 0.09 ± 0.02mm (cold), (0.004" ± 0.001" inches) • Exhaust - 0.14 ± 0.02mm (cold), (0.006" ± 0.001" inches) Inspect Spark Arrester Screen (CARB models) WARNING Hot Surfaces. When operating machine, do not touch hot surfaces. Keep machine away from combustibles during use. Hot surfaces could result in severe burns or fire. 1. Loosen clamp (A) and remove screw. 2. Inspect screen (B) and replace if torn, perforated or other- wise damaged. If screen is not damaged, clean with commercial solvent. 3. Replace spark arrestor cone (C) and screen (B). Secure with clamp and screw. Owner's Manual for Portable Generator 15