Dynex DX-L26-10A User Manual (English) - Page 18

14 Understanding the basics 4 Press to highlight Time Zone, then press or to select your time zone. Auto Scan may take a while to complete. A progress report is displayed while your TV is scanning for available channels. You can press MENU to exit Auto Scan prior to completion, but you will need to run Auto Scan later to complete the process. Auto Scan creates a list of available/receivable channels for the selected signal input. 5 Press to highlight DST (Daylight Saving Time), then press or to select On (to automatically change the time for Daylight Saving Time), or Off (to ignore it or set it yourself). 6 Press to highlight Air/Cable, then press or to select Air or Cable, depending on the type of antenna connection you have. Understanding the basics Turning your TV on or off To turn your TV on or off (standby mode): 1 Plug the power cord into an AC power outlet. 2 Press (power). Your TV turns on. 3 Press again to turn off your TV. When you turn off your TV, it goes into standby mode. Warning: When your TV is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord. Note: If your TV does not receive an input signal for several minutes, it automatically goes into standby mode. Selecting the video input source To select the video input source: 1 Turn on your TV, then press the INPUT key on the remote, or the INPUT button on the TV. The INPUT SOURCE menu opens. 7 Press to highlight Auto Scan, then press ENTER or to automatically scan for available channels. 2 Press or to highlight the video source, then press ENTER. You can also select the input source using the following remote control buttons: • COMP-Press to select Component. • HDMI-Press once to select HDMI1. Press twice to select HDMI2. • VIDEO-Press once to select AV1. Press twice to select AV2. Press three times to select S-Video. • TV-Press to select TV.