Dynex DX-L26-10A User Manual (English) - Page 8

4 Installing the stand or removing the stand column Installing the stand or removing the stand column Cautions • Read these instructions carefully before you try to assemble the stand or remove the stand column. • Make sure that you handle the TV carefully when attempting to assemble or remove the stand. If you are not sure of your ability to do this or to use the tools required, contact a professional installer or service technician. Dynex is not responsible for any damages or injuries that occur because of mishandling or incorrect assembly. • When using a table or bench as an aid in assembly, make sure that you use a soft cushion or covering to prevent scratching or damage to the TV screen or cabinet. • The speaker is not intended to support the weight of the TV. Do not move or handle the TV by the speaker. This can cause damage that is not covered by your warranty. • Before assembly or removal of the stand, unplug the power cord. You need to install the TV into the stand to use the TV in an upright position on a flat surface. For instructions, see "Installing the stand" on page 4. If you plan to wall-mount the TV, you need to remove the stand column. For instructions, see "Removing the stand column" on page 5. Installing the stand You need to install the stand to use the TV in the upright position on a flat surface. Note: The appearance of the TV may differ from the illustrations in this task. To install the stand: 1 Remove the stand from the box and place it on a table or bench. 2 Lay the TV flat (screen down) on the edge of a table or bench. Make sure that you put a soft cushion or cloth between the table or bench and the TV. 3 Examine the stand carefully. The column socket is not in the center of the stand. You need to make sure you align the stand shown in the following illustration. Long Column socket Short Stand Short Long Stand 4 Place the stand close to the end of the stand column and keep the angle between the TV and the stand at 30° or less, then fully insert the stand column into the column socket on the stand. 5 Adjust the stand angle until it is at a 90° angle to the TV. Table edge 6 Move the stand gently until the locators on the stand column align with the locating grooves on the stand, then use four screws (provided) to secure the stand to the column. Two locators Table edge Stand column To remove the stand, loosen the four screws. Locating grooves Four screws