E-Z-GO Shuttle 22 TXT - Electric Owner Manual - Page 50
Hardware, Table 1, Torque Specifications and Bolt Grades
View all E-Z-GO Shuttle 22 TXT - Electric manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
MAINTENANCE PROCEDURES Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. Hardware Periodically, the vehicle should be inspected for loose fasteners. Fasteners should be tightened in accordance with the Torque Specifications table. Use care when tightening fasteners and refer to the Technician's Repair and Service Manual for specific torque values. Generally, three classes of standard hardware and two classes of metric hardware are used in the vehicle. Grade 5 hardware can be identified by the three marks on the hexagonal head and grade 8 hardware is identified by 6 marks on the head. Metric hardware is marked on the head with 8.8 or 10.9. Unmarked hardware is Grade 2. ALL TORQUE FIGURES ARE IN FT. LBS. (Nm) Unless otherwise noted in text, tighten all hardware in accordance with this chart. This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners. BOLT SIZE 1/4" 5/16" 3/8" 7/16" 1/2" 9/16" 5/8" 3/4" 7/8" 1" Grade 2 4 8 15 24 35 55 75 130 125 190 (5) (11) (20) (33) (47) (75) (102) (176) (169) (258) Grade 5 6 13 23 35 55 80 110 200 320 480 (8) (18) (31) (47) (75) (108) (149) (271) (434) (651) Grade 8 6 18 35 55 80 110 170 280 460 680 (8) (24) (47) (75) (108) (149) (230) (380) (624) (922) BOLT SIZE M4 Class 5.8 1 (Grade 2) 5.8 (2) Class 8.8 2 (Grade 5) 8.8 (3) Class 10.9 3 (Grade 8) 10.9 (4) M5 M6 M8 M10 M12 M14 2 4 10 20 35 55 (3) (6) (14) (27) (47) (76.4) 4 7 18 35 61 97 (6) (10) (24) (47) (83) (131) 6 10 25 49 86 136 (8) (14) (34) (66) (117) (184) Table 1: Torque Specifications and Bolt Grades Page 44 Owner's Guide