E-Z-GO Shuttle 22 TXT - Electric Owner Manual - Page 59

Using A Hydrometer, electrolyte, subtract

Page 59 highlights

MAINTENANCE PROCEDURES Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. NOTICE Do not perform a hydrometer test on a battery that has just been watered. The battery must go through at least one charge and discharge cycle in order to permit the water to adequately mix with the electrolyte. The temperature of the electrolyte is important since the hydrometer reading must be corrected to 80° F (27° C). High quality hydrometers are equipped with an internal thermometer that will measure the temperature of the electrolyte and will include a conversion scale to correct the float reading. It is important to recognize that the electrolyte temperature is significantly different from the ambient temperature if the vehicle has been operated. Using A Hydrometer 1. Draw electrolyte into the hydrometer several times to permit the thermometer to adjust to the electrolyte temperature and note the reading. Examine the color of the electrolyte. A brown or gray coloration indicates a problem with the battery and is a sign that the battery is nearing the end of its life. 2. Draw the minimum quantity of electrolyte into the hydrometer to permit the float to float freely without contacting the top or bottom of the cylinder. 3. Hold the hydrometer in a vertical position at eye level and note the reading where the electrolyte meets the scale on the float. 4. Add or subtract four points (.004) to the reading for every 10° F (6° C) the electrolyte temperature is above or below 80° F (27° C). Adjust the reading to conform with the electrolyte temperature, e.g., if the reading indicates a specific gravity of 1.250 and the electrolyte temperature is 90° F (32° C), add four points (.004) to the 1.250 which gives a corrected reading of 1.254. Similarly if the temperature was 70° F (21° C), subtract four points (.004) from the 1.250 to give a corrected reading of 1.246. 5. Test each cell and note the readings (corrected to 80° F or 27° C). A variation of fifty points between any two cell readings (example 1.250 - 1.200) indicates a problem with the low reading cell(s). As a battery ages the specific gravity of the electrolyte will decrease at full charge. This is not a reason to replace the battery providing all cells are within fifty points of each other. Since the hydrometer test is in response to a vehicle exhibiting a performance problem , the vehicle should be recharged and the test repeated. If the results indicate a weak cell, the battery or batteries should be removed and replaced with a good battery of the same brand, type and approximate age. Owner's Guide Page 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

Owner’s Guide
Page 53
MAINTENANCE PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Do not perform a hydrometer test on a battery that has just been watered. The battery must go through at least one charge
and discharge cycle in order to permit the water to adequately mix with the electrolyte.
The temperature of the
electrolyte
is important since the hydrometer reading must be corrected to 80° F (27° C). High
quality hydrometers are equipped with an internal thermometer that will measure the temperature of the electrolyte and will
include a conversion scale to correct the float reading. It is important to recognize that the electrolyte temperature is signifi-
cantly different from the ambient temperature if the vehicle has been operated.
Using A Hydrometer
1.
Draw electrolyte into the hydrometer several times to permit the ther-
mometer to adjust to the electrolyte temperature and note the reading.
Examine the color of the electrolyte. A brown or gray coloration indi-
cates a problem with the battery and is a sign that the battery is near-
ing the end of its life.
2.
Draw the minimum quantity of electrolyte into the hydrometer to per-
mit the float to float freely without contacting the top or bottom of the
cylinder.
3.
Hold the hydrometer in a vertical position at eye level and note the
reading where the electrolyte meets the scale on the float.
4.
Add or subtract four points (.004) to the reading for every 10° F (6° C)
the electrolyte temperature is above or below 80° F (27° C). Adjust
the reading to conform with the electrolyte temperature, e.g., if the
reading indicates a specific gravity of 1.250 and the electrolyte tem-
perature is 90° F (32° C),
add
four points (.004) to the 1.250 which
gives a corrected reading of 1.254. Similarly if the temperature was
70° F (21° C),
subtract
four points (.004) from the 1.250 to give a cor-
rected reading of 1.246.
5.
Test each cell and note the readings (corrected to 80° F or 27° C). A
variation of fifty points between any two cell readings (example 1.250
- 1.200) indicates a problem with the low reading cell(s).
As a battery ages the specific gravity of the electrolyte will decrease at
full charge. This is not a reason to replace the battery providing all cells
are within fifty points of each other.
Since the hydrometer test is in response to a vehicle exhibiting a per-
formance problem , the vehicle should be recharged and the test re-
peated. If the results indicate a weak cell, the battery or batteries
should be removed and replaced with a good battery of the same
brand, type and approximate age.
NOTICE