Electrolux ELFG7437AG Complete Owners Guide - Page 42

42 CARE AND CLEANING • When cleaning chrome parts, it is best to use only a damp cloth. • Before moving the dryer, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent damage to the floor. thread the fittings. DO NOT allow the hose to rub against sharp objects. Always ensure the hose fitting rubber gasket is installed and free from water leaks when water pressure is applied. WARNING FIRE HAZARD A clothes dryer produces combustible lint. The dryer must be connected to an outdoor exhaust. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the opening and in the surrounding area. Rubber Washers Must Be Present USE ONLY NEW HOSES Limited use, vacation, and away from home IMPORTANT DO NOT store or place laundry products on top of dryer at any time. They can damage the finish or controls. It is recommended to keep laundry products in the storage drawer between cycles if installed on a pedestal. CAUTION Your dryer should be operated ONLY when you are home. If you are away from home or not using your dryer for extended periods of time, follow these steps: 1. Turn off the water supply to dryer (steam models only) to avoid water leaks due to water pressure surges and unforeseen occurrences in the water supply. 2. Disconnect or unplug the electrical power to the dryer. Reconnecting water supply and electrical IMPORTANT When reinstalling the dryer after disconnecting the water supply lines (steam models only) and electrical power, please follow the steps below: Water inlet hose inspection (steam models only) Periodically inspect all water inlet hoses for water leaks, wear, cuts, corrosion and bulges. Replace all hoses, if any sign of the above is visible. All hoses should be replaced every 5 years to reduce the risk of hose failures. When replacing hoses, refer to the installation instructions for proper installation. DO NOT overtighten or cross 1. Review the installation instructions provided with the dryer to ensure the appliance is level and the water and electrical power supply is properly connected. 2. Ensure the water lines are flushed of debris, prior to connecting the water lines to the dryer inlet. 3. Check for water leaks and replace supply hoses if needed.