Electrolux ELFG7437AG Complete Owners Guide - Page 9
PRE²INSTALLATION REQUIREMENTS, Installation Checklist
View all Electrolux ELFG7437AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PRE-INSTALLATION REQUIREMENTS 9 Installation Checklist Exhaust Venting Free-flowing, clear of lint buildup 4 inch (102 mm) rigid metal or semi-rigid metal transition ducting of minimal length and turns NO foil or plastic venting material Approved vent hood exhausted to outdoors Leveling Dryer is level, side-to-side and frontto-back Cabinet is sitting solid on all corners Gas Supply (Gas Dryer) Manual shutoff valve present in supply All connections sealed with approved sealer and wrench tight Conversion kit for LP GAS system # PCK4200 (not included) and must be purchased separately Gas supply turned on No leaks present at all connections check with soapy water, NEVER check with flame Water Hookup (Select Models) Inspect hoses for proper placement of rubber washers Water supply is turned on Check for leaks Steam model dryers require use of ASSEMBLY HOSE Kit #5304495002 (not included) and must be purchased separately. 240v Electric Supply (Electric Dryer) Approved NEMA 10-30 or 14-30 service cord with all screws tight on terminal block Approved strain relief installed Terminal access cover installed before initial operation Door Reversal Follow detailed instructions in this manual Test hinge and latch for function Electrical Power House power turned on Dryer plugged in Final Checks Installation Instructions and Use & Care Manual read thoroughly Door latches and drum tumbles when cycle starts Registration card sent in