Epson 10600 Printer Guide - Page 12

Introduction | 5 Note If you are not using Photo Printing Accelerator in your driver (see page 1-33 for details), or if you are using a software or hardware RIP, you must have a Pentium III 700 MHz or higher processor with 512MB RAM to keep the printer running at full engine speed. Caution Using an improperly shielded USB cable- especially a cable more than 6.6 ft. (2 meters) long-may cause the printer to malfunction. Windows System Requirements To use your printer in either a standalone or peer-to-peer network environment, your system should include the requirements listed below: • IBM®-compatible PC with a Pentium® III 500 MHz (Pentium IV 1.3 GHz or higher processor recommended) • For parallel connection: Windows 95, 98, Me, NT 4.0, 2000, or XP For USB connection: PC with USB port running Windows 98 (factory installed), Me, 2000, or XP For IEEE 1394 connection: PC with FireWire port running Windows Me, 2000, or XP For 10/100 BaseT Ethernet connection: Ethernet equipped PC running Windows 95, 98, Me, NT 4.0, 2000, or XP • 256MB of RAM (512MB or more recommended) • At least 50MB of free hard disk space to install the software, and at least 150MB of free hard disk space for processing files (2GB or more available hard disk space recommended) • Quad-speed (4×) CD-ROM or DVD drive for installing the printer software • For parallel connection: a high-speed bidirectional, IEEE-1284 compliant parallel cable, 6 to 10 ft. (1.8 to 3 m) long, with a D-SUB, 25-pin, male connector for your computer and a 36-pin, Centronics® compatible connector for the printer For USB connection: a computer running Windows 98, Me, or 2000 with a Windows compliant USB port and a shielded USB "AB" cable from Series A (computer) to Series B (printer), up to 6.6 ft. (2 meters) long For IEEE 1394 (FireWire) connection: a compliant IEEE 1394 port and a shielded IEEE 1394 cable For network connection: an RJ-45 Ethernet cable 5