Epson C82WN User Setup Information - Page 26

4. Note the IP Address that appears on the screen. If the address is 192.0.0.192, you will need to enter a new address, as described below. If any other number appears here, the address has been assigned by your existing network, through a technology called DHCP (Dynamic Host Configuration Protocol). In most cases, you can leave this setting as it is, and skip to step 7. 5. If 192.0.0.192 appears in the IP Address box and you are not using DHCP, enter an address that will work with your computer(s) and network. For example, if your computer's IP address is 192.189.207.3, the print server's IP address should begin with 192.189.207. The last part of the address can be any number between 1 and 254 except 3 or 4. See page 54 for instructions on viewing your computer's IP address. 6. In most cases, you can leave the Boot Method set to Auto. If you entered an IP address manually, set the Boot Method to STATIC. 7. If your existing network uses WEP encryption, do the following: ■ Select either 64BIT or 128BIT in the WEP Key box, depending on which version of WEP your network supports. ■ Enter your WEP key in either the 128Bit Key 1 box or the 64Bit Key 1 box. Note: You can enter up to four WEP keys on the screen. (Changing your WEP key periodically adds to network security.) To communicate, every node on the network must use the same WEP key. For more information about WEP keys, check the documentation for your wireless adapter or access point. ■ If you're using an access point, set the Wireless Mode to Infrastructure. (Remember to enable WEP and reset the wireless mode on your computer when you're done configuring the print server.) 8. Make sure the SSID matches your network's name or SSID. If it doesn't match, your print server may have received an IP address from another access point. Change the SSID to match the network you want to use. 22 Configuring Wireless Printing for Windows