Epson Endeavor User Manual - VGA Utilities Guide - Page 28
Configuring GEM for the New Drivers, Insert the GEM/3 System Master Disk in drive A.
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Configuring GEM for the New Drivers Follow these steps to configure GEM to use the new VGA drivers: 1. Insert the GEM/3 System Master Disk in drive A. 2. Log onto drive A. 3. Type the following and press Setup program: to start the GEM/3 GEMSETUP 4. Follow the instructions on the screen until you see Change existing configuration. 5. Select OTHER (DRIVER PACK). You'll be prompted to insert a screen driver into drive A. 6. Insert the GEM DRIVRPK diskette you created in drive A. You'll see the two drivers listed below: Cirrus Logic VGA 16 Color 800 x 600 Cirrus Logic VGA 16 Color 1024 x 768 7. From this list, select the driver you want to use. 8. Follow the instructions on the screen to complete the installation. 24 VGA Utilities
Configuring GEM for the New Drivers
Follow these steps to configure GEM to use the new VGA
drivers:
1.
2.
3.
Insert the GEM/3 System Master Disk in drive A.
Log onto drive A.
Type the following and press
to start the GEM/3
Setup program:
GEMSETUP
4.
Follow the instructions on the screen until you see
Change existing
configuration.
5.
Select
OTHER
(
DRI
VE
R PACK
).
You’ll be prompted to
insert a screen driver into drive A.
6.
Insert the GEM DRIVRPK diskette you created in drive A.
You’ll see the two drivers listed below:
Cirrus Logic
V
GA
16 Color 800 x 600
Cirrus Logic
V
GA 16 Color 1024 x 768
7.
From this list, select the driver you want to use.
8.
Follow the instructions on the screen to complete the
installation.
24 VGA Utilities