Epson PowerLite 9100i User Manual - Page 111
Remote Control Information
View all Epson PowerLite 9100i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Remote Control Information You can operate the projector by remote control via a line-of-sight infrared (IR) receiver at the front and rear of the projector. The projector may not respond to remote control commands under the following conditions: I There is an object between the remote control IR emitter and the IR receiver on the projector. I Ambient light is too bright. I Certain types of fluorescent lighting are used. I A strong light source shines into the IR receiver. I Other equipment that emits infrared energy, such as a radiant room heater, is in the room. These conditions commonly cause problems for most infrared-controlled equipment. Try the following: I The remote control batteries may be low on power; replace them. I Dim the ambient lighting and/or turn off any fluorescent lights. I Close any window coverings and/or move the projector out of direct sunlight. I Turn off other equipment that emits infrared energy. If the remote control still does not work properly, remember you can always control your computer-based presentation directly from the computer, even in an environment containing one of the conditions listed above. Notices 105