Epson Stylus Pro GS6000 Setup and User's Guide - Page 92
Moving the Printer on the Stand, Disconnect the power cord and interface cable.
View all Epson Stylus Pro GS6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
92 | Cleaning, Storing, and Transporting the Printer Caution: Do not remove the ink cartridges or leave the print head uncapped when moving the printer; otherwise the print head may dry out and be unable to print properly. Never turn off the printer by disconnecting the power cord or turning off power to the electrical outlet. Do not tilt the printer, stand it on end, or turn it upside down when moving it, or ink will leak and you may damage the printer. Moving the Printer on the Stand When you need to move the printer a short distance, such as within the same building, you can roll the printer on its casters. 1. Open the right maintenance cover and make sure the print head is on the right side (in the capped position). If it is not capped, turn on the printer, wait a moment, then turn it off and check again. Never move the print head by hand. 2. Dispose of any waste ink in the waste ink tank (see page 78). 3. Press the P Power button to turn off the printer. 4. Disconnect the power cord and interface cable. 5. Make sure the front cover is closed. 6. Rotate the feet counter-clockwise to raise them. Caution: Do not roll the printer on angled or uneven surfaces. 7. Carefully roll the printer to its new location, then rotate the feet clockwise to stabilize the stand. 92