Epson T-1000 User Manual - Page 19

Loading continuous-feed paper, Move the print head to the center of the printer. Remember,

Get Epson T-1000 - ActionPrinter- Impact Printer PDF manuals and user guides View all Epson T-1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Using Continuous-feed Paper 6. In each tractor slot, located at each side of the paper slot, is a peg that fits into the notch on each of the rear tractor legs. Tilt the tractor back so that the rear notches fit over these pegs, as shown below. 7. Then tilt the unit forward until the front legs snap into place. Loading continuous-feed paper Once the tractor unit is installed, load continuous-feed paper as follows: 1. Make sure that the printer is turned off. 2. Remove the front lid of the printer. 3. Move the print head to the center of the printer. Remember, the printer must be turned off whenever you move the print head. Also, if you've been using the printer, the print head may be hot. Be careful not to touch it unless you let it cool for a few minutes. 1-12 Setting Up

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
Using Continuous-feed
Paper
6.
In each tractor slot, located at each side of the paper slot, is a peg
that fits into the notch on each of the rear tractor legs. Tilt the
tractor back so that the rear notches fit over these pegs, as shown
below.
7.
Then tilt the unit forward until the front legs snap into place.
Loading continuous-feed paper
Once the tractor unit is installed, load continuous-feed paper as follows:
1.
Make sure that the printer is turned off.
2.
Remove the front lid of the printer.
3.
Move the print head to the center of the printer. Remember, the
printer must be turned off whenever you move the print head. Also,
if you’ve been using the printer, the print head may be hot. Be
careful not to touch it unless you let it cool for a few minutes.
1-12
Setting Up