Epson T-1000 User Manual - Page 80
Inserting the interface board, The screw marked CG at the rear of the circuit board is
![]() |
View all Epson T-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
installing an Interface Inserting the interface board 1. Locate the connector cover at the back of the upper case, shown in the illustration below. Push it down and in, toward the inside of the printer, until it clicks. You need to move the cover to allow access to the new interface connector when the case is reassembled. 2. The screw marked CG at the rear of the circuit board is the connection for the frame ground wire. Unscrew it and then use it to connect the frame ground wire as shown below. A-6 Appendix
![](/manual_guide/products/epson-t1000-user-manual-870b262/80.png)
installing an Interface
Inserting the interface board
1.
Locate the connector cover at the back of the upper case, shown in
the illustration below. Push it down and in, toward the inside of the
printer, until it clicks. You need to move the cover to allow
access
to
the new interface connector when the case is reassembled.
2.
The screw marked CG at the rear of the circuit board is the
connection for the frame ground wire. Unscrew it and then use it to
connect the frame ground wire as shown below.
A-6
Appendix