Fujitsu MAJ3364MP Manual/User Guide - Page 103
Dismounting Drives, 5.8 Spare Disk Drive, Remove the power cable.
View all Fujitsu MAJ3364MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
a. Control mode parameters Parameter • Queue algorithm modifier • QErr: • DQue: Resume or abort remaining suspended commands after sense pending state Disabling tagged command queuing Default value 0 (Ordering is executed by read command only.) 0 (command is resumed) 0 (enabled) 5.7 Dismounting Drives Since dismounting the drive to check the setting terminals, change the setting, or change the drive depends on the structure of the system cabinet, the work procedures must be determined in consideration of the requirements specific to the system. This section describes the general procedures and notes on dismounting the drive. It is recommended before dismounting the drive to make sure the spindle motor completely stops after power was turned off. a) Remove the power cable. b) Remove the SCSI cable. c) When the external operator panel is mounted, remove the cable. If it is difficult to access the connector position, the cable may be removed after step e). d) Remove the DC ground cable. e) Remove the four mounting screws securing the drive, then remove the drive from the system cabinet. f) To store or transport the drive, keep it in an antistatic bag and provide packing (see Section 5.1). 5.8 Spare Disk Drive See Appendix D, "Model Names and Product Numbers," to order a disk drive for replacement or as a spare 5 - 22 C141-E103-02EN