Garmin Alpha 200i Owners Manual - Page 22

tempe The tempe is an ANT+ wireless temperature sensor. You can attach the sensor to a secure strap or loop where it is exposed to ambient air, and therefore, provides a consistent source of accurate temperature data. You must pair the tempe with your device to display temperature data from the tempe. Tips for Pairing ANT+ Accessories with Your Garmin Device • Verify that the ANT+ accessory is compatible with your Garmin device. • Before you pair the ANT+ accessory with your Garmin device, move 10 m (33 ft.) away from other ANT+ accessories. • Bring the Garmin device within range 3 m (10 ft.) of the ANT+ accessory. • After you pair the first time, your Garmin device automatically recognizes the ANT+ accessory each time it is activated. This process occurs automatically when you turn on the Garmin device and only takes a few seconds when the accessories are activated and functioning correctly. • When paired, your Garmin device receives data from only your accessory, and you can go near other accessories. T 5 Battery Replacement Instructions T 5 Components Back plate Power key Battery connector Battery cover Battery Power connector Removing the Old Battery Before you replace the battery, you must remove all dirt, water, and debris from the device. You must also have a small Phillips screwdriver. 1 Remove the six screws from the outer edges of the back plate. NOTE: You should leave the two inner screws in place. 2 Pry off the back plate. 3 Disconnect the battery connector and power connector. 4 Remove the screws that secure the battery cover. 5 Remove the battery cover and the battery. Remember the orientation of the battery. You must install the new battery the same way. After you remove the old battery, contact your local waste disposal department to properly recycle the battery. Installing the New Battery Before you replace the battery, you must remove the old battery (Removing the Old Battery, page 18). You also must have a small Phillips screwdriver. You may need a small flat screwdriver. 1 Install the new battery using the same orientation as the old battery. The connector should face the end nearest the power key, and the bump where the wires connect to the battery should face toward the side with the charging clip contacts. 2 Replace the battery cover. 3 Replace the screws to secure the battery cover. 4 Connect the battery connector and power connector. You may need to use a flat screwdriver to help secure the connectors. 5 Select the power key to test the connections. When properly connected, a tone is emitted and the status LED blinks green. 6 Turn off the device. 7 Verify the gasket located inside the bottom cover is fully seated. 8 Replace the back plate. 9 Replace the six screws to secure the back plate. After you install the new battery, charge the collar completely. Replacing the T 5 mini Dog Collar Device Battery Before you can replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and the security screwdriver included in the battery replacement kit. 1 Remove the screws from the L-shaped cover over the VHF antenna. 2 Pry off the L-shaped cover. 3 Remove the screws from the outer edges of the back plate. 4 Pry off the back plate. 5 Grip the battery connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the battery connector from the device. 6 Grip the power connector wires close to the connector, and pull the connector parallel to the circuit board to disconnect the power connecter from the device. 7 Remove the screws from the battery plate. 8 Remove the battery plate. 9 Remove the battery. The battery fits tightly. It may be necessary to pry the battery out of the back plate using a non-sharp, non-metal object. 10Install the new battery into the front enclosure with the label side of the battery facing up, and the leading edge of the battery placed under the charging contact ledge of the device. 11Replace the battery plate, and replace and tighten the two screws. 18 Appendix