GE P2S975SEPSS Installation Instructions - Page 1
GE P2S975SEPSS - 30" Slide-In Dual-Fuel Range Manual
UPC - 084691199236
View all GE P2S975SEPSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Self-Cleaning Dual Fuel Instructions Slide-In Range P2S975 Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com In Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.ca IN THE COMMONWEALTH OF MASSACHUSETTS: • This product must be installed by a licensed plumber or gas fitter. • When using ball-type gas shut-off valves, they shall be the T-handle type. • A flexible gas connector, when used, must not exceed 3 feet. BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Product failure due to improper installation is not covered under the Warranty. WARNING - This appliance must be properly grounded. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty. WARNING - Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 31-10641-3 03-09 JR Printed in the United States FOR YOUR SAFETY Anti-Tip Bracket Kit Included If you did not receive an anti-tip bracket with your purchase, call 1.800.626.8774 to receive one at no cost. (In Canada, call 1.800.561.3344.) For installation instructions of the bracket, visit: GEAppliances.com. (In Canada, www.GEAppliances.ca.) PARTS INCLUDED Rear Filler 2 Screws Screws MATERIALS YOU MAY NEED Joint Sealant Pipe Fittings Shut Off Valve Lag Bolts Anchor Sleeves (For Concrete Floors Only) CSA-Approved Flexible Gas Line 3/8″ Min. ID, 1/2″ NPT Connection, 3-foot Maximum Length (Massachusetts only) TOOLS YOU WILL NEED • 1/4" Nut Driver • Tape Measure • Phillips Head Screwdriver • Level • Drill • Flat Head Screwdriver • Pipe Wrench • Safety Glasses • Wrench or Pliers (for 1 7/16" Nut) 1