GE P2S975SEPSS Installation Instructions - Page 12

Installation Instructions INSTALL THE RANGE (CONT.) 22 REPLACE THE OVEN DOOR NOTE: The oven door is heavy. You may need help lifting the door high enough to slide it into the hinge slots. Do not lift the door by the handle. A Lift the oven door by placing one hand on each side. The door is heavy, so you may need help. Do not lift the door by the handle. 23 REPLACE THE STORAGE DRAWER A Place the drawer rail on the guides. B Push the drawer in until it stops. C Lift the front of the drawer and push in until the stops clear the guides. D Lower the front of the drawer and push in until it closes. B With the door at the same angle as the removal position (halfway between the closed and broil stop position), seat the notch of the hinge arm into the bottom edge of the hinge slot. The notch of the hinge arm must be fully seated into the bottom of the slot. Hinge arm Bottom edge of slot Hinge notch C Open the oven door as far as it will open. D Push the hinge locks up against the front frame of the oven cavity, to the locked position. Hinge in locked position Notch of hinge securely fitted into bottom of hinge slot E Close the oven door. Stop SPECIAL INSTRUCTIONS IF YOU ARE HAVING PROBLEMS WHILE REPLACING THE STORAGE DRAWER If Drawer Won't Close: Drawer Power cord may be obstructing drawer in this area Drawer does not close completely Rear drawer support is resting on top of guide rail front panel tipped away from body side Remove and replace, making sure the power cord is not obstructing the drawer and/or the rail is in the guide. If Drawer is Crooked: Rear drawer support is on top of guide rail on the high side Drawer front panel tipped to one side Remove and replace, making sure the rail is in the guide. 12