GE P2S975SEPSS Installation Instructions - Page 15
Alternate Construction, Preparation - parts
UPC - 084691199236
View all GE P2S975SEPSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation Instructions 25 ALTERNATE CONSTRUCTION PREPARATION A OPTIONAL MAINTOP FILLER OR BACKGUARD KIT If counter opening extends to the wall, it will require Maintop Filler Kit (supplied with the range) or Backguard Kit (JXS32XX or JXS37XX) to close the gap. NOTE: If the countertop is greater than 25″, it will show a gap between the backguard and wall or between filler kit and the wall. If the countertop is less than 25″, a gap will occur between the countertop front and the control panel ends (see Step 8). If you are using the optional backguard kit, refer to the backguard kit instructions for installation details. Wall Must be 25″ level Must be flat 30″ smooth cut Must be level 31-1/8″ Must be flat If you use the filler kit, place the metal filler piece supplied with the range to the back of the range as shown in the figure below. Start the 2 screws into the upper holes at the outside rear of the range and through the slots in the trim, holding the filler piece centered on the maintop frame and pushing upward to close the gap between the bottom of the maintop and the filler trim. When the trim is set in the proper position, tighten the 2 mounting screws. The top of the trim should be located below the top surface of the maintop to prevent pots, pans and skillets from damaging the painted parts. Refer to the Standard Installation of the Range on page 5. Cooktop Range Maintop filler (2) #8 screws B FOR NON-BUILT-IN INSTALLATION (END OF CABINET LOCATION) When installing the range at the end of a cabinet section which will expose the unfinished side of the range, use Body Side Kit (JXS77XX). Refer to the kit instructions or installation details. C ISLAND INSTALLATION Attach the anti-tip bracket per the instructions that are supplied with the bracket. Be aware that the screws provided are long and may penetrate though the back of the island cabinets. Follow the instructions included with the bracket. Do not use Backguard Kit JXS32XX or JXS37XX. D CABINETS OVER THE RANGE LESS THAN 30″ If a 30″ clearance between cooking surface and overhead combustible material or metal cabinets cannot be maintained, protect the underside of the cabinets above the cooktop with not less than 1/4″ insulating millboard covered with sheet metal not less than 0.0122″ thick. 15