GE P2S975SEPSS Installation Instructions - Page 2

Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY: WARNING - If the information in this manual is not followed exactly, a fire, explosion or gas leak may result causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance! WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. This range has been design certified by UNDERWRITERS LABORATORIES for use in the United States and Canada. You'll find safety precautions in your Owner's Manual. Read them carefully. • Installation of this range must conform with local codes or in the absence of local codes with the National Fuel Gas Code, ANSI Z223.1-Latest edition. • Be sure your range is installed properly by a qualified installer or service technician. • To eliminate reaching over surface burners, cabinet storage above burner should be avoided. • Do not install the unit near an outside door or where a draft may affect its use. FOR YOUR SAFETY: WARNING - For personal safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or even death. All rough-in and spacing dimensions must be met for safe use of your range. Electricity to the range can be disconnected at the outlet without moving the range if the outlet is in the preferred location (remove lower drawer). To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage space above the cooktop should be avoided. If cabinet storage space is to be provided above the cooktop, the risk can be reduced by installing a range hood that protrudes at least 5" beyond the front of the cabinets. Cabinets installed above a cooktop must be no deeper than 13". Be sure your appliance is properly installed and grounded by a qualified technician. ELECTRICAL REQUIREMENTS This appliance must be supplied with the proper voltage and frequency and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse having a recommended amperage rating per the table below. BREAKER OR FUSE SIZE 240V 40 Amps 208V 40 Amps NOTE: Check Local Codes for required breaker size. Rating plate is located above the storage drawer below the oven frame. Rating plate location We recommend you have the electrical wiring and hookup of your range connected by a qualified electrician. After installation, have the electrician show you where your main range disconnect is located. 2