GE PDW7900P Installation Instructions - Page 10
Installation, instructions, PORTANT
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation instructions STEP 17-CONNECT DRAIN LINE FOLLOW ALL LOCAL CODES AND ORDINANCES. .... The motded end of the drain hose will fit 5/8" through 1" : diameter inlet ports on the air gap, waste tee or disposer. , Determine size of inlet port • Cut drain hose connector on the marked line, if required, to fit the inlet port. DRAIN LINE INSTALLATION ° Connect drain line to air gap, waste tee or disposer using the" previously determined method. Method I - Air gap with waste tee or disposer Cutting Line # IMPORTANT: Do not cut corrugated portion of hose Figure X • If a longer drain hose is required and gou did not purchase drain hose GPFIOL, odd up to 42" length for a total of 120" 110feet} to timefactorg installed hose. Use 5/8" or 7/8" inside diameter hose and o coupler to connect the two hose ends. Secure the connection with hose clamps. Waste Tee Installation Figure Z Disposer Installation Method 2 - Built-in "High drain loop" with waste tee or disposer Fasten to underside of cauntertop -- :-- .... k l tr--]Z' Min. Fasten to underside of counte_op Hose Clamp Hose Clamp I r Waste Tee Instatfatian Figure AA Disposer Installation Figure Y • Secure the drain hose to the air gap, waste tee or disposer with c!omps. Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPERDRAIN OPERATION, IM PO RTANT- Whenconnectingdraliinnteo disposer, check to be sure that the drain f==7= plug has been removed. DISHWASHER WILL L__ 4--Remove Drain NOT DRAIN IF PLUG IS LEFT I I Plug iN PLACE. CCT Tip: Avoid unnecessarg service coil charges. Prior to connecting drain hose be sure excess hose is not trapped, kinked or crushed by the dishwasher. Pull excess hose through the cabinet opening to prevent hose damage and pump out: issues. lo