GE PDW7900P Installation Instructions - Page 7

Installation Instructions STEP 8-POSITION WATER LINE AND HOUSE WIRING o Position water supply line and house wiring on the floor of the opening to avoid interference with bose of dishwasher end components under dishwasher, STEP IO-SLIDE DISHWASHER THREE-FOURTHS OF THE WAY INTO CABINET DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR, • Slide dishwasher into the opening a few inches at o _ime, Figure N House Wiring \ STEP 9-INSERT DRAIN HOSE THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. tf e power cord is used, guide the end through o separate hole. Drain -Hose Length 10' Blanket Figure N (If Power is NOT Used} Power Cord (If Used) Tip: Position water line and house wiring on the floor to avoid interference with base of dishwasher. ...d _Do Not Push Against Front Door Panel With Knee, Damage to The Door Pone! Will Occur. Figure0 • As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher extends about 6 inches forward of adjacent Cabinets. ° Hake sure drain hose is not kinked under the dishwasher and there is no interference with the water line and wiring or any other component. STEP 11-INSTALL TRIM PIECES Skip this step if trim is not supplied with the dishwasher. o Locate the four trim pieces set aside in Step 1. o Position the trim pieces so the lips face toward the dishwasher door. • Select o long trim piece and press it onto the left side tub flange. Start with the top edge and press the trim piece completely onto the tub flange as you move towards the bottom. Repeat for the right side tub flange trim piece. • Select one of the short trim pieces, Instal] it on the top tub flange to the left of the door latch. Select the remaining short piece of trim end install it on the top tub flange to {he right of the door latch. Trim Stri Figure P