GE PDW7900P Installation Instructions - Page 5
<caution
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Instructions PREPARE HOT WATER LINE • The line mug enter from either side. rear or floor within the shaded urea shown in Figure F. • The line may pass through the some hole as the electrical cable and drain hose. Or, cut on additional 1-1/2" diameter hole to accommodate the water fine. If power cord with plug is used, water line must not pass through power cord hole. STEP 2-CHECK DOOR BALANCE o With dishwasher on the wood skid, check the door balance bg opening and closing the door. • If the door drops when released, increase the spring tension. If the door rises when released, decrease ttne tension. Note: Increase or decrease tension as shown. Adjust both springs to the some tension setting to correct balance. Increase Spring • Tens,onA _'l "".., ::::i:_.;;' }:_ ! '\ /::::i/ IY_ t Insert Hook t __:, ; _::_, /_::_ lOver Bracket f_t:_ _ / : / : _k_J / i i Shut-. HOt:_...V...a...l.v. e i_.::::.:'::. CFarboimnet _ !9" From Wall :: / Cobinet Foce-_- FigureF _L[/_ 2,,From Fioor Water Line Connection °Turn off the water supply. ° Install o hand shut-off valve in on accessible locution, such us under the sink. (OptionoI, but strongly recommended and may be required by local codes.} , Water connection is on the left side of the dishwasher. Install the hot water inlet line, using no less than 3/8" copper tubing. Route the line as shown in Figure F and extend forward at least 197from rear woti .... o Adjust water heater for 120°Fto 150°Ftemperature. ,:Flush water line to clean out debris. : ,The ho:twater supply line pressure must be 20-120 PSI. :